Beretta 92 Elite LTT II FAQ's

Q. Can I get it in .40 S&W?

1. No!

 

Q. Is it available in a Compact or Centurian version?

1. Not at this time. 

 

Q. Does it come with the smaller Vertec Grip Panels?

1. No, those would be a separate purchase. 

 

Q. Will the Elite II fit in standard Elite Holsters?

1. Yes, the Elite II fits in standard Elite, M9A4, and 92X holsters if they are built to accommodate a red dot optic. The Elite II will fit legacy M9A1 holsters, but the front sight may be too tall for some of those holsters' sight channels. 

 

Q. Will the Elite II take an extended & threaded barrel for compensator or suppressor use?

1. Yes, the Elite II uses the same barrels as other full-size Beretta 92s. 

 

Q. Can I get Night Sights or a Fiber Optic front sight for my Elite II?

1. Not currently. The front sight that comes on the Elite II is specifically intended to be used as a backup iron sight for use with a red dot optic, not as a primary sighting system.  

 

Q. I love the grips I have on my standard Elite. Can I swap those over to my Elite II?

1. No, the Elite II uses the Vertec frame and will not take grips from the normal full-size 92 frames. 

 

Q. Can I put a normal 92 F style safety lever on the Elite II?

1. Yes, the Elite II uses the new style G lever and can be swapped out with a standard F-style lever that stays in the safe position. 

Q. Will the LTT RDO front sight work with the Beretta Factory cover plate? 

1. No, the sights will not provide a proper point of aim/point of impact since the LTT RDO front sight sits taller than the Beretta factory baseplate rear sight. The LTT RDO front sight will also not work with the factory RMR plate, you must use the factory provided front sight.