SUPER DUTY SHOTGUN SIGHT INSTALLATION INSTRUCTIONS

Permanently deleted user
Permanently deleted user
  • Updated

  1. First, remove the factory front sight with a thin 5.5mm wrench
  2. Install the nut into the insert so that the domed Nylok portion of the nut is visible.
    •  Note: The Nylok is a threadlocker. Loctite is not necessary for this assembly.
  3. Install the insert into the front sight base
  4. Place the front sight onto the front sight base
  5. Install the screw and tighten to 25 in/lbs
    1.  Note that the screw may leave fine thread marks inside of your front sight base hole. This is intentional and allows the assembly to be more robust.
    2.  Once tightened, there may be a slight gap below the insert because it is being pulled firmly up against the top of the front sight base. That is normal and will not affect function.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.